Walplast Pvt Ltd

ADT Industries is one of the largest suppliers and project partners of Ready Mix walplast products. It’s designed to provide smooth finish on internal (Plastering) & external (Rendering) surface with stronger bond to substrate. Ready Mix Plaster gives strong adhesion on wall/ceiling with excellent water resistant, crack free workability’s that will protect wall. It provides flat base for painting, minimize the inconvenience of maintenance, and speed up the construction. We supply these products to Mumbai, and rest of the India region.

APPLICATIONS:

-Clean loose particles, dirt, grease and traces of foreign materials from the surface, if necessary, by using wire brush/sandpaper or by chipping.

-For loose plaster areas or walls which are not even, then remove the defective material. The surface should be properly clean.

-The substrate should damp and excess water to be swept off.

-Take approx.150-250 ml of clean water for 1 Kg of READY - MIX MORTAR in a clean bucket. It is very important that add material into water and not vice versa.

-Mix continuously for 4-5 minutes by using wooden trowel to obtain a homogeneous lump- free mixture.

-Allow the resultant paste to stand for about 5 minutes for the additives to dissolve.

-Re-mix again for about 2 Minutes. The mixture is now ready to apply.

-Apply plaster to the substrate by using some pressure with a steel/wooden trowel.

-Spread a mixture evenly to the required thickness & finish using straight edge.

-Apply aluminium level patty from bottom to top direction followed by left to right and right to left direction to level the plaster.

-Plain plaster wall ready for next application

-Curing can be started after 24-hour, it is recommended 2-3 times a day for 7 days.

-Do not add more water than recommended.

-The maximum thickness for the 1st coat should not exceed 10-12 mm.

-READY - MIX MORTAR contains non-toxic material but still, it is important to wear a safety kit when mixing and handling.